Rivet nut
Rivet nut, countersunk head, rifled under the head, open, steel, zinc plated
BLIND RIVET NUT COUNTERSUNK ZN 6X15
With registration you can access the Würth Elektro online shop selection.
Simple and ideal when the place of use is
a thin material where threads are needed.
Round:
The most common when working on a steel sheet,
with normal loads.
Countersunk head:
Used when
flush joint is needed.
Open model:
An effective and strong piercing nut thread without special requirements on the tightness of the joint
Datasheets(X)
Thread type x nominal diameter (D) | M6 |
Length (L) | 15 mm |
Min./max. grip range (E) | 1.50-3.80 mm |
Head diameter (d2) | 12 mm |
Head type | Countersunk head |
Head height (K) | 1.55 mm |
Drill hole diameter | 9 mm |
Outer diameter (d1) | 8.9 mm |
Tension force | 16900 N |
Max. tightening torque | 14 Nm |
Design | Open |
Material | Steel |
Surface | Zinc plated |
Last viewed
Self-fusing shrink adhesive tape
Circuit breaker
Hexagon socket screw, flat round head
Signal cable LIYCY
Cable routing conduit end component LKM
Safety label 793 series, WMB, WAGO
Button/indicator light shield Osmoz
Helawrap – split spiral binding
Charging station load management control unit EVlink Home Peak Controller 1-phase
Cable routing conduit T-piece LKM