Drill tip screw, cylinder head, AW drive pias®
Zinc-plated steel, blue passivated (A3K), AW drive
DIN 7504-N AW ZP 3,5X9,5
With registration you can access the Würth Elektro online shop selection.
Drilling, threading, and screwing – all in one working phase
Noticeably less time and effort required
Precise bore diameter in each screw connection
- Minimal thread tolerance
- Always an optimum fixing
Prevents errors in installation
AW drive system:
- Improved torque transmission
- Longer useful life
- Precise centring
- Improved fastening result due to less straining screw-in; contact pressure required by torque noticeably reduced
- Maximum tip contact area while twisting
- Even force distribution protects coating, improving corrosion resistance
Also included: 1 tip
Contact pressure during use approx. 100 N; if necessary, a screw depth setter can be used.
- Diameters 4.2 and 4.8 mm:
- European Technical Approval ETA-10/0184
Zinc-plated drilling screws may only be used in places where no moisture is expected. For building control authority approved fastening elements, the approval and particularly part 2, Special Conditions, must be followed.
Can be stored in the ORSY® system
Datasheets(X)
 | |
Nominal diameter (d) | 3.5 mm |
Length (l) | 9.5 mm |
Head diameter (d) | 6.9 mm |
Head details | 0 - not applicable |
Last viewed
Circuit board support TRDLCBST
Taptite DIN 7500-M, countersunk head, thread rolling
Base 221-Inline with drainage system Wago
Hexagon screw, full thread
Film junction box VBS
Adhesive pad
Crimp sleeve WESO4
Telecom outlet 2 x RJ45 CAT6 UTP, Jussi
Hexagon nut, low profile
Valena Life Netatmo switch on/off