Tapping screw pan head DIN 7981-C
Tapping screw, pan head, DIN 7981-C, stainless steel A2, PZ, type C
DIN 7981-C PZ A2 4,8X13
With registration you can access the Würth Elektro online shop selection.
When screwing in pre-drilled holes, tapping screws remove material when biting into the fastening material, rolling a thread.
Types
- Type C: thread and cone tip
- Type F: thread and flat tip
- Type R: thread and rounded tip
Stainless steel sheet metal screws are softer than case-hardened steel tapping screws. This means they bite poorly into the fastening sheet metal. Therefore they are only recommended for use in soft materials, e.g., aluminium.
Datasheets(X)
 | |
Nominal diameter (d) | 4.8 mm |
Length (l) | 13 mm |
Head diameter (d) | 9.5 mm |
Head height (k) | 3.55 mm |
Last viewed
Cable spiral wrap
Wall bracket VK hot dip galvanised, Meka
Slotted screw ISO 14580
Signal cable FLEX-JZ-CY
Hexagon socket screw, cylinder head
Serrated lock washer, serrated washer, externally serrated, type A
Circuit board support TRMDLSP3
Circuit breaker Acti 9 iC60N
Plug connector male WINSTA DALI
Pipe end cap plastic