Tapping screw pan head DIN 7981-C
Tapping screw, pan head, DIN 7981-C, acid-resisting steel A4, PZ, type C
DIN 7981-C PZ A4 3,9X16
With registration you can access the Würth Elektro online shop selection.
When screwing in pre-drilled holes, tapping screws remove material when biting into the fastening material, rolling a thread.
Types
- Type C: thread and cone tip
- Type F: thread and flat tip
- Type R: thread and rounded tip
Stainless steel sheet metal screws are softer than case-hardened steel tapping screws. This means they bite poorly into the fastening sheet metal. Therefore they are only recommended for use in soft materials, e.g., aluminium.
Datasheets(X)
 | |
Nominal diameter (d) | 3.9 mm |
Length (l) | 16 mm |
Head diameter (d) | 7.5 mm |
Head height (k) | 2.8 mm |
Last viewed
Blind rivet domed head open
Fender washer, wing repair washer
Defogger Adax Neo
Linear luminaire IP44 Linear Surface Gen 2
Cable trunking, screw mounting, WDK
Casing pipe bend metal
Three-phase residual current device IP44, electric power
Push button releasable Osmoz
ENLARGER PA PG/PG Polyamide
Slotted cable trunking ECS