Rotary dimmer LED, body Impressivo
LIGHT CONTROLLER 2-400W/VA UPO
ABB
With registration you can access the Würth Elektro online shop selection.
Low LED rotary dimmer (device), flush-mount depth 20mm. Impressivo centre plates are ordered separately.
The LED rotary knob controller is a 2-wire solution (N-wire is not needed). Either RL or RC operation can be selected from the controller. The power range of the controller is 2-100 VA for LED loads. 10-400 W for other loads (see installation instructions). Linear and low-noise adjustment is possible thanks to the MOSFET transistors.
Electronic short circuit and overload protection. The general brightness level can be changed by adjusting the potentiometer in the upper right corner of the device (min adjustment). Use in AC connection is possible following the installation instructions.
Datasheets(X)
Last viewed
Slotted screw pan head DIN 7985
Hexagon socket screw, flat cylinder head
Taptite DIN 7500-M, countersunk head, thread rolling
Hexagon socket screw, cylinder head
Circuit board support TRMDLSP3
Corner component Instal
Flush-mounted switch IP21 Exxact
Hexagon socket screw, cylinder head
Time relay Zelio
Installation cable MMJ