Base load ELKO RS16
REGULATOR BOTTOM LOAD 4715 ELKO RS16
SCHNEIDER ELECTRIC
With registration you can access the Würth Elektro online shop selection.
A base load can be helpful in situations where a light or motor controller does not control the load over the entire control range, when instead flicking or such occurs. The base load is connected (as seen from the controller) parallel to the load.
If the load is a low-voltage halogen lamp, connect the base load to the primary side of the transformer.
Datasheets(X)
Last viewed
Surface-mounted luminaire IP65 Surface Bulk Head with motion detector
Drywall box HW set 050
Hexagon socket screw, cylinder head
Round flexible cable trunking HelaDuct Flex
Signal cable FLEX-JZ
Spacer screw SIUL MSNI
Defrosting cable Ebeco Frostvakt 10
Surface-mounted luminaire IP44 Surface Circular 250 Sensor
Plastofast, pan head
Taptite DIN 7500-M, countersunk head, thread rolling