Rivet bush WERH, ZN
RIVET BUSH WERH ZP M3 1,8-2,2
With registration you can access the Würth Elektro online shop selection.
WERH is an internally threaded rivet bush with a serrated collar.
When installing, the collar is riveted around the hole and
the serrations are pressed into the base material, ensuring a strong
and permanent fitting.
• Suitable for very thin and hard materials.
• Well suited for aluminium, light metal, magnesium, etc.
• Can be installed with hand tools or automatic machines.
• Suitable for both drilled and punched holes.
• Suitable for materials up to 5.1 mm thick.
• Also suitable for joining two sheets together.
• Wide range of use. M2.5 - M12
Datasheets(X)
 | |
Min./max. grip range | 1.8-2.2 mm |
Min./max. drill hole diameter | 5.54-5.59 mm |
Height | 3.17 mm |
Last viewed
LED lamp LEDVANCE DULUX F LED (CCG/AC) to replace TC-F 24W
End plate 2002 series, TOPJOB®S
Hexagon screw, full thread
Flush-mounted outlet IP20 Valena
Signal cable FLEX-JZ
Sound-proofing component Instal
Circuit board support TRLCBS2
Electrical tape vinyl HelaTape FLEX15
Chipboard screw, cylinder head stainless steel A2, TX
Wire marker roll 2.5 to 16 mm2 Helagrip HGDC