Rivet nut
Rivet nut, round, reduced head, open, steel, galvanised
RIVETNUT ZN ROUND RED.H. M3X8,7
With registration you can access the Würth Elektro online shop selection.
Simple and ideal when the place of use is
a thin material where threads are needed.
Round:
The most common when working on a steel sheet,
with normal loads.
Reduced head:
Used in a sheet when what is needed is a
joint level with the surface. Separate
countersinking is not needed.
Open model:
An effective and strong piercing nut thread without special requirements on the tightness of the joint
Datasheets(X)
 | |
Thread type x nominal diameter | M3 |
Length | 8.7 mm |
Min./max. grip range | 0.50-2.00 mm |
Head diameter | 5.3 mm |
Drill hole diameter | 4.8 mm |
Assembly force | 1700 N |
Tension force | 4400 N |
Max. tightening torque | 1.2 Nm |
Design | Open |
Material | Steel |
Surface | Zinc plated |
Last viewed
Cable clamp CCA zinc plated, Meka
Lighting outlet housing AKL3
Auxiliary contactor block CTXMINI
Tapping screw raised countersunk head DIN 7983-C
Combination thermostat EB-THERM 205
Neutral bar N and PE bars with 16 mm2 pillar terminals, Ensto
Thread-forming bushing WES
Contactor CTX3 65
Defrosting cable Ebeco Frostvakt 10
Contactor AF09