Rivet nut
Rivet nut, round, reduced head, grooved, open, steel, galvanised
RIVETNUT ZN ROUND RED.H.KN. M4X10,4
With registration you can access the Würth Elektro online shop selection.
Simple and ideal when the place of use is
a thin material where threads are needed.
Suitable for material thicknesses of 0.25 – 10.5 mm.
Round grooved:
Gives better torque grip.
Very suitable for thinner material thicknesses and plastics.
Reduced head:
Used in a sheet when what is needed is a
joint level with the surface. Separate
countersinking is not needed.
Open model:
An effective and strong piercing nut thread without special requirements on the tightness of the joint.
Datasheets(X)
 | |
Thread type x nominal diameter | M4 |
Length | 10 mm |
Min./max. grip range | 0.50-2.00 mm |
Head diameter | 7 mm |
Drill hole diameter | 6.1 mm |
Assembly force | 3900 N |
Tension force | 7900 N |
Max. tightening torque | 2.9 Nm |
Design | Open |
Material | Steel |
Surface | Zinc plated |
Last viewed
Flush-mounted switch 10AX – 250V IP20 Valena Life
Defogger Adax Neo
Plafond light with motion sensor Surface Bulk Head, IP65
Slotted screw pan head DIN 7985
Open industrial luminaire Trusys Flex DALI
Motor protection switch MS116
Cable trunking, adhesive tape mounting ECMA
Connector WMT UC stainless steel A4, Meka
Hexagon socket screw, flat round head