Rivet nut
Rivet nut, round, reduced head, grooved, open, steel, galvanised
RIVETNUT ZN ROUND RED.H.KN. M6X14,5
With registration you can access the Würth Elektro online shop selection.
Simple and ideal when the place of use is
a thin material where threads are needed.
Suitable for material thicknesses of 0.25 – 10.5 mm.
Round grooved:
Gives better torque grip.
Very suitable for thinner material thicknesses and plastics.
Reduced head:
Used in a sheet when what is needed is a
joint level with the surface. Separate
countersinking is not needed.
Open model:
An effective and strong piercing nut thread without special requirements on the tightness of the joint.
Datasheets(X)
 | |
Thread type x nominal diameter | M6 |
Length | 14.5 mm |
Min./max. grip range | 0.50-3.00 mm |
Head diameter | 10 mm |
Drill hole diameter | 9.1 mm |
Assembly force | 5800 N |
Tension force | 16500 N |
Max. tightening torque | 10.1 Nm |
Design | Open |
Material | Steel |
Surface | Zinc plated |
Last viewed
Plastic enclosure TG PC
Wall mounting set Cubo O/C
LED candle lamp CLASSIC B LED PARATHOM DIM glass matte
Floodlight Floodlight PFM, IP65
Snow melting mat Ebeco Snowmat
Hexagon nut, fine thread
Through standoff WESO
Energy transfer chain cable EMC HF PUR-C
Circuit board support TRMDLSP3
Dimmer switch NOCTURNE