Rivet nut
Rivet nut, round, reduced head, grooved, open, steel, galvanised
RIVETNUT ZN ROUND RED.H.KN. M6X16,5
With registration you can access the Würth Elektro online shop selection.
Simple and ideal when the place of use is
a thin material where threads are needed.
Round grooved:
Gives better torque grip.
Very suitable for thinner material thicknesses and plastics.
Reduced head:
Used in a sheet when what is needed is a
joint level with the surface. Separate
countersinking is not needed.
Open model:
An effective and strong piercing nut thread without special requirements on the tightness of the joint
 | |
Thread type x nominal diameter | M6 |
Length | 16.5 mm |
Min./max. grip range | 3.00-5.50 mm |
Head diameter | 10 mm |
Drill hole diameter | 9.1 mm |
Assembly force | 5800 N |
Tension force | 16500 N |
Max. tightening torque | 10.1 Nm |
Design | Open |
Material | Steel |
Surface | Zinc plated |
Datasheets (0)
Certificates/ Documents (0)
Last viewed
Charging station load management control unit EVlink Home Peak Controller 1-phase
Terminal block 2002 series 3-conductor TOPJOB® S
Panel luminaire frame Panel PFM 600
Flush-mounted switch 10AX/250V, IP44 Valena Life
Flange bolt, hexagon head
Signal cable FLEX-JZ
Cable routing conduit aluminium, Instal
Emergency light Easy Combo self contained
Hexagon screw, full thread