Taptite, TT2000, cylinder head, thread-rolling screw
Cylinder head ISO 14583, stainless steel A2
TAPTITE PANHEAD TT2000 TX10 A2 M3X12
With registration you can access the Würth Elektro online shop selection.
- This Taptite screw forms its own thread in many steels, light metals, alloys, etc.
- The thread’s forming torque is always lower than the screw’s maximum screw-in torque.
- Please see standard DIN 7500-2 for reference values for correct initial hole diameters.
- No chipping occurs during fastening, as the thread is cold-formed into the base material; this also improves connection strength.
- An excellent locking screw for pieces exposed to vibration; the connection might not need separate locking adhesives or washers. Screw-to-hole clearance very small, thread’s thread coverage large.
- If necessary, normal metric-thread screws may be mounted into threads rolled with Taptite screws.
- Taptite screws made of stainless steel (A2) can only safely be used in light metals.
The applicable application or component must be tested beforehand for compatibility with the thread-rolling GEFU screw. Please see standard DIN 7500-2 for reference values for correct initial hole diameter choice.
Datasheets(X)
 | |
Thread type x nominal diameter (d) | M3 |
Length (l) | 12 mm |
Head diameter (d) | 5.6 mm |
Head height (k) | 2.4 mm |
Internal drive | TX10 |
Guideline values for hole diameters | 2.8 mm |
Material | Stainless steel A2 |
Surface | Plain |
RoHS-compliant | Yes |
Last viewed
Thermal relay RTX3 100
Auxiliary contactor block CA6-11M
C connector
Spiral binding, cable protector, standard
Cylindrical pin, grooved
Enclosed industrial luminaire Damp Proof Slim Value, IP65
Pluggable interface relay CR-U series
Inductive sensor Embeddable, OsiSense
Surface mounting frame downlight Downlight Slim SQ
Hexagon socket screw, cylinder head